Huskie Tools Inc. Single-Acting Hydraulic Pump, 1/2 HP, 120VAC (10,000 psi)

The R-14EH remote operated pump gives the operator complete control. Push buttons permit the user to advance and retract at will. The user is never committed to a full cycle|and can always back off at any time during the advance even under pressure. This feature increases efficiency because cuts and crimps can be adjusted as necessary|simply by stopping the advance or retract mode. A 10-foot remote control cable provides both safety and convenience. The user can set up an operation and then move away from the work site before engaging the tool. An over-ride switch on the pump allows full control at the pump motor. The low amperage of this pump allows it to be used virtually anywhere. The pressure can be easily adjusted between 4,000 and 10,000 psi and determined by using our PG-1 in-line gauge. Consult factory for proper adjusting procedure. The pump is operated on 120V AC current.; NOTE: When using any of these high pressure tools|always use 10,000 psi rated non-conductive hose (NC-16 series).

R-14EH Specifications

• Remote Operation Allows Full Operator Control
• Advance and Hold Feature Standard
• Manual Control Directly on Pump Motor
• Pressure Adjustment from 4,000-10,000 psi